Gate Repair in Pontiac - Fixed Today, No Surprise Invoice

Gate Repair in Pontiac, MI

Gate motor and opener repair in Pontiac is the call we make most often, and the reason is almost always the same: the gate was installed on a post that froze and heaved, and the motor has been fighting a racked frame for years. Pontiac’s housing stock runs from the 1920s through the 1960s, and a lot of those original iron gates are still standing. When a new owner takes possession after a long vacancy, the opener is often burned out from pushing against a gate that no longer swings straight. Call (928) 260-0864 and we’ll send a technician who writes the price down before any work starts.

Call (928) 260-0864

Why Pontiac Homes Are Different

Frost drives gate work in Pontiac more than any other factor. Michigan frost reaches 36 to 42 inches deep in an average winter, which means a gate post set in a shallow 1950s footing will heave upward unevenly year after year. The gate starts to drag on the latch side, then the hinge side, and eventually the motor burns out trying to move it. Road salt makes it worse. Gates along Woodward Avenue and M-59 take overspray every winter, and that salt works its way into hinge pins, roller bearings, and motor mounts faster than in southern Oakland County suburbs. We see post footings original to Pontiac’s mid-century homes sitting several inches out of plumb, and the only fix that lasts is re-setting the post, not just greasing the hinge. Nobody who only replaces the latch and walks away solves a Pontiac gate problem for more than one season.

Our Main Pontiac Services

Most Pontiac homeowners reach us for one of two reasons, an existing gate that stopped working or a plan to put in a new one on a property that may have sat empty for years. Both start the same way: we look at the post, the frame, and the ground before quoting anything.

Gate Repair in Pontiac

When a gate in Pontiac seizes, racks, or drops on its hinges, the cause is usually years of deferred maintenance rather than one sudden event. We repair the frame, the hardware, and the motor as one system, because patching a hinge on a post that heaved six inches is not a repair, it’s a delay. Our written price covers what we found, and we photograph every adjustment before we leave. Gate Repair in Pontiac covers the full scope of this work.

Gate Installation in Pontiac

A new gate in Pontiac needs a footing poured below frost depth or it will be crooked by spring. Many of the lots we survey have existing fence lines that are still straight, but the gate opening has narrowed as posts leaned inward over decades. We measure for the new gate, set posts below the 42-inch frost line, and spec a motor matched to the gate’s weight and swing. Gate Installation in Pontiac explains materials, timing, and what gets quoted in writing before the first hole is dug.

Before

After

Gate Motor & Opener in Pontiac

Gate motor and opener calls in Pontiac are dominated by frost-heaved posts and salt-corroded mounts. A motor that draws high amps trying to move a gate that no longer travels true will fail early, and the real fix is to correct the gate’s travel before the new motor goes in. We service the motor that’s already on your property, whichever brand it is, and every visit ends with a written record of what was set and what was replaced. Gate Motor & Opener is the full service breakdown.

Motor Installation

Signs you need it

The motor hums but the gate does not move, or the gate moves in short bursts and stops.

What it costs in Pontiac

Motor installation in Pontiac typically runs $450-$950 depending on the motor model and whether the mounting plate needs repair.

How we do it

We remove the failed motor, inspect the drive arm and mounting plate, install the new motor, and set the open and close limits before testing the full cycle under load.

Motor Repair

Signs you need it

The gate opens but will not close, or it reverses immediately after touching the close limit.

What it costs in Pontiac

Motor repair in Pontiac typically costs $180-$500 depending on whether the fault is in the limit switch, capacitor, or gearbox.

How we do it

We trace voltage at the board, identify the failed component, replace only what is bad, and photograph the new component in place.

What Gate Motor & Opener Costs in Pontiac

Can you repair my existing motor instead of replacing it?

Yes. We repair before we recommend replacement. If the motor is serviceable and the failure is a limit switch, capacitor, or control board, we fix that at the lower end of the range and leave the motor in place.

What does a Pontiac frost heave do to a gate motor?

It changes the gate’s swing geometry so the motor works harder every cycle. If we reset the post, the new or repaired motor operates within its rated load instead of slowly burning out.

Gate Access Control in Pontiac

Gate access control in Pontiac means adding or repairing the method that lets someone in, a keypad, a card reader, a phone entry system, or a remote. Older Pontiac properties often have one entry point caked with decades of corrosion, and wiring that was run before modern low-voltage standards. We diagnose the whole circuit from the keypad to the control board before writing a price. Gate Access Control is the complete technical breakdown.

Keypad Entry

Signs you need it

Keys work but the keypad buttons are unresponsive or only some digits register.

What it costs in Pontiac

Keypad entry repair or replacement in Pontiac typically runs $200-$450.

How we do it

We test each key circuit, clean or replace the weather seal, mount the new keypad, and program the entry codes before verifying the relay triggers the motor.

Remote Control

Signs you need it

One remote opens the gate but another does not, or the range has dropped to a few feet.

What it costs in Pontiac

Remote programming or replacement in Pontiac typically costs $100-$250.

How we do it

We clear the receiver memory, pair new remotes, and check antenna placement so the signal reaches from the street rather than only from the driveway apron.

What Gate Access Control Costs in Pontiac

Can you install a keypad if I have never had one?

Yes, we can add a keypad to most existing gate motors and run the low-voltage wiring to the control board. The quote is written before any work starts and includes the programming and testing.

What if my gate opener is old and the access control will not pair?

We check the receiver frequency and protocol first. Many older boards can be adapted with a new receiver, which is far cheaper than replacing the whole motor and control system.

Gate Parts & Welding in Pontiac

Gate parts and welding in Pontiac is where we spend a lot of time on ornamental iron original to the house. Hinges seize, posts rot at the base, rails bend from snowplow contact, and the fix is often a weld rather than a replacement part that no longer exists. We weld in place where possible, and we re-set posts below frost depth when the ground has moved. Gate Parts & Welding covers the full metalwork scope.

Hinge Replacement

Signs you need it

The gate scrapes the ground on the latch side or sags visibly when open.

What it costs in Pontiac

Hinge replacement in Pontiac typically runs $150-$400 per hinge, including the weld.

How we do it

We support the gate, cut the old hinge free, weld the new one to the post and frame, then check the swing before the weld cools fully.

Post Replacement

Signs you need it

The gate post leans, has visible cracks at the concrete base, or the gate will not stay latched after any adjustment.

What it costs in Pontiac

Post replacement in Pontiac typically costs $350-$700 per post with a new concrete footing poured below frost depth.

How we do it

We remove the old post and footing, auger the new hole to at least 42 inches, set the post plumb in concrete, and re-hang the gate after the concrete has cured enough to hold load.

What Gate Parts & Welding Costs in Pontiac

Do you weld cast iron or only steel?

We weld steel and wrought iron daily. Cast iron is trickier and requires a different rod and preheat, so if your gate is cast iron, we will tell you what is possible before we put a torch to it.

How does Pontiac road salt affect gate hinges?

Salt pits the pin surface and eats the grease out of the hinge barrel, which accelerates wear to the point the gate drops. We replace hinges with sealed-bearing units where the frame allows it.

Brands We Service in Pontiac

We work on Viking, Ghost Controls, DoorKing, and Elite motors in Pontiac, among others, and we carry common boards, remotes, and limit switches for these brands in local stock. The brand determines the board layout and part number, not whether we can fix it, and most parts arrive within one to two business days when we do not already have them. Our brands page lists the full range.

Pricing for Gate Repair in Pontiac, MI

Neighborhoods We Serve in Pontiac

We work across Pontiac from downtown residential blocks to the older neighborhoods that ring the city center. Most calls can be scheduled within one to three days, and emergency gate failures get same-day attention when a vehicle is trapped behind a seized gate.

• Downtown Pontiac
• Seminole Hills
• Franklin Park
• Ottawa Hills
• Northwest Pontiac

Service Area - Cities Near Pontiac

Our crews also take gate repair calls in Waterford, MI, Sterling Heights, MI, Southfield, MI, and nearby Troy, OH when the job is a fit. The same written pricing and photo record applies on every job, no matter which side of the map it is on. If your gate is in one of these cities or close to the Pontiac line, call or use the home page to find the right service.

FAQs About Gate Repair in Pontiac