Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair in Union City, GA
Gate motor and opener work in Union City, GA usually starts with a call about a gate that won’t open, or worse, one that stopped mid-travel and locked a car in the driveway. Most of the driveways we work on here were built with the house, meaning the gate hardware went in with the subdivision and has been through 30 to 50 years of Georgia humidity and red clay ground movement. Call us at (928) 260-0864 and we’ll have a technician look at it, quote a price in writing, and get it moving again.
Why Union City Homes Are Different
Union City sits on a stretch of South Fulton County where the soil is heavy clay that expands when it rains and contracts in the dry heat of July and August. That cycle quietly works against gate posts year after year. We regularly see gates in the older neighborhoods near I-85 and Highway 29 where the posts have drifted enough to throw the gate leaf off its hinges or bind the motor against the rack. The housing stock runs from 1960s brick ranch homes to the newer subdivisions closer to the interstate, and each era has its own failure pattern: old swing gates with welded hinges that rust through at the barrel, newer slide gates with operators that were never serviced after installation. Humidity also does a number on circuit boards and limit switches, especially on equipment mounted in unventilated metal enclosures.
Our Main Union City Services
Most homeowners in Union City reach out to us first for either a repair on an existing gate or a full replacement. Here’s how each works in this city.
Gate Repair in Union City
Repair work in Union City is usually about keeping the gate you already have, and we quote every repair with that goal unless the damage is structural. We handle broken hinges, bent leaves, failed operators, misaligned tracks, and rusted posts. On older Decoto-style ranch properties with original iron work, we often find the hinge barrels have worn oblong and the gate sags far enough to drag on the driveway. We can usually rebuild the hinge point and re-hang the leaf the same visit. For more on the repair process in Union City, see our dedicated Gate Repair in Union City page.
Gate Installation in Union City
A new gate in Union City has to account for clay soil and drainage. We set posts in concrete below the active movement zone, and for automatic gates we run the wiring in conduit rated for wet locations. HOA communities along Flat Shoals Road and near Ronald Bridges Park often require approval before the first hole is dug, and we can help you put together the submittal drawings. Our full installation approach is detailed on the Gate Installation in Union City page.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterGate Motor & Opener in Union City
Gate motors in Union City fail most often because of moisture intrusion and neglected limit switches. A motor that hums but won’t move has usually burned a capacitor or seized a gearbox after years of fighting a gate that was never lubricated or re-aligned. We service every major brand on site, and the work is documented end to end. See our Gate Motor & Opener hub for a fuller look at what goes into a proper motor service call.
Motor Repair
Signs you need it
The gate opens partway and reverses, or you hear a humming sound but the leaf doesn’t move.
What it costs in Union City
Motor repair in Union City typically falls between $220 and $410, depending on whether we’re replacing a capacitor or rebuilding a gear assembly.
How we do it
We bench-test the motor, isolate the failed component, quote a flat price, and photograph the repair before and after.
Linear Motor
Signs you need it
Your slide gate stutters along the track or stops dead halfway through its travel.
What it costs in Union City
Linear motor replacement here runs $450 to $800 installed, with the price finalized before any work starts.
How we do it
We pull the old operator, mount the new one, set travel limits, and photograph the wiring and final position.
What Gate Motor & Opener Costs in Union City
| Item | Typical range in Union City |
|---|---|
| Motor repair | $220 - $410 |
| Linear motor replacement | $450 - $800 |
| Full automation package (operator, remote, safety edges) | $1,300 - $2,700 |
Can you fix a gate opener the same day in Union City?
In most cases, yes. We keep motors and common control boards stocked for BFT, Linear, and Ghost Controls, and a technician can usually reach most Union City neighborhoods within the same day.
Do you work on HOA gates in Union City?
Yes. We handle access-controlled HOA gates near Union Landing and along Buffington Road. Call (928) 260-0864 and we’ll send someone out, do a written assessment, and quote the repair flat before anyone picks up a tool.
Gate Access Control in Union City
Union City is home to a growing number of HOA communities and light commercial properties that need access control on their gates. Keypads, remotes, phone entry, and video intercoms all fail differently, but the common thread here is Georgia heat on outdoor enclosures and rain driving into unprotected electronics. We work on entry systems for both residential driveway gates and small neighborhood perimeters. For the full range of access control work, see our Gate Access Control hub.
Keypad Entry
Signs you need it
Codes that worked last week stop working, or the keypad doesn’t respond even with fresh batteries.
What it costs in Union City
Keypad entry repair or replacement in Union City typically runs $150 to $380, including programming.
How we do it
We test voltage at the keypad, replace the unit or wiring as needed, program the master code, and photograph the setup for your records.
Video Intercom
Signs you need it
The screen flickers, the camera shows nothing, or the inside monitor won’t talk to the outside station.
What it costs in Union City
Video intercom repair or replacement is $390 to $1,000, depending on wire condition and panel model.
How we do it
We check the cable between units, replace the camera or monitor, and re-terminate all connections with weatherproof connectors.
What Gate Access Control Costs in Union City
| Item | Typical range in Union City |
|---|---|
| Keypad entry repair/replacement | $150 - $380 |
| Video intercom | $390 - $1,000 |
| Full access control integration | $700 - $1,800 |
Do you work on Viking access systems in Union City?
Yes. We service Viking, DoorKing, and Linear access equipment, and we keep common Viking parts in the van. Most keypad or card reader repairs can be done on the first visit.
Can you add phone entry to an existing gate in Union City?
In most cases, yes. Phone entry is a practical upgrade for HOA gates and can be tied into an existing operator. Call (928) 260-0864 for a written quote.
Gate Parts & Welding in Union City
Older Union City gates, especially the swing gates on 1970s and 1980s ranch properties, fail at the weld and hinge points before anything else. Clay soil movement keeps pressure on welds, and rust never fully stops. We weld on site and keep a mobile welding rig stocked for steel and wrought iron repairs, so a broken hinge or a snapped rail doesn’t mean a new gate. For more on what we build and repair, see Gate Parts & Welding.
Hinge Replacement
Signs you need it
The gate drags on the driveway on the latch side, or you can see daylight between the hinge barrel and the post.
What it costs in Union City
Hinge replacement runs $180 to $360 for most residential gates, including cutting and re-welding.
How we do it
We cut the old hinge off, weld on a new barrel and pin, and align the gate leaf so it swings without binding.
Post Replacement
Signs you need it
The post leans, the gate won’t latch, or the concrete at the base has cracked and shifted.
What it costs in Union City
Post replacement in Union City runs $350 to $700, including digging, new concrete, and setting the post.
How we do it
We remove the old post, dig past the clay layer, set a steel post in concrete, and re-hang the gate.
What Gate Parts & Welding Costs in Union City
| Item | Typical range in Union City |
|---|---|
| Hinge replacement | $180 - $360 |
| Post replacement | $350 - $700 |
| Custom welding (per hour) | $80 - $140 |
Can you weld a broken gate on site in Union City?
Yes. We carry a mobile welder and can repair most cracks and snapped rails at the house. If the break is severe, we quote a replacement section before starting.
Do you stock gate parts locally for Union City homes?
We keep hinges, rollers, wheels, and brackets in the van, and our parts stock covers BFT, Linear, and Ghost Controls operators. Most mechanical repairs don’t require a second trip.
Brands We Service in Union City
We service BFT, Linear, and Ghost Controls operators, along with most other major brands on the market. Common parts are stocked locally so repair work doesn’t stall on a shipping delay. See our brands for the full list.
Pricing for Gate Repair in Union City, GA
| Service | Typical range in Union City |
|---|---|
| Motor repair | $220 - $410 |
| Linear motor replacement | $450 - $800 |
| Keypad entry repair/replacement | $150 - $380 |
| Video intercom | $390 - $1,000 |
| Hinge replacement | $180 - $360 |
| Post replacement | $350 - $700 |
| Custom welding (per hour) | $80 - $140 |
| Full automation package | $1,300 - $2,700 |
| Access control integration | $700 - $1,800 |
What pushes prices up in Union City is usually rust-damaged posts, clay movement that requires a deeper footer, or HOA requirements that add submittal time. We give every customer a written price before any work starts, and that number doesn’t change at the end of the job.
Neighborhoods We Serve in Union City
We work throughout Union City and the surrounding South Fulton area, from the older subdivisions off Highway 29 to the newer HOA communities near I-85. Response time for most neighborhoods is under two hours.
- Shannon Villas
- Paces Lakes
- Gullatt Estates
- Oakley Township
- Campbellton
Service Area - Cities Near Union City
We also serve the communities around Union City, including Douglasville, GA, Mableton, GA, Atlanta, GA, and Stockbridge, GA. If your gate is in one of these areas, the same written-price policy applies.
Serving Union City, GA - Our Local Coverage Area
We’re based in the Union City area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in Union City
Most neighborhoods in Union City are within a two-hour response window, and we can often be there faster for a gate stuck open or closed. Call (928) 260-0864 and a live person will answer.
For repair work, usually not. But if you’re in an HOA-governed community off Flat Shoals Road or near Ronald Bridges Park, some bi-laws require approval for changes to visible hardware. We can help you check.
Yes. We come out, assess the gate, and give you a written price before any work starts. You’ll never be asked to commit to a repair without a number on paper.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Union City Customers Say
"They installed the opener and left me a diagram of the wiring and the limit settings. When I needed a second remote programmed I could do it myself."
- Nadine C."The safety loop had never been installed correctly by the previous company. They showed me the reading, fixed it, and did not charge me for the diagnosis."
- Patrick H."Our gate was hit by a delivery truck. They came out, documented the damage properly for the insurer, and the claim went through without an argument."
- Camille R.